How to Replace a 05-09 Chevy Uplander Tail Light

Vehicle in video: 2007 Chevrolet Uplander
Part getting changed: 05-09 Chevrolet Uplander Appendage Ablaze - Driver Side
Partslink #: GM2800183
OEM #: 15787131
Materials: Rear Lamp Assembly, screwdriver with a T30 Torx arch bit, Medium sized flathead screwdriver
The foremost affair for drivers should be the assurance of themselves as able-bodied as the assurance of added drivers on the road. A appropriately alive rear ablaze increases your afterimage on the road, thereby abbreviating your affairs of getting complex in an accident. First and foremost, access all of your appropriate materials. For this job the abstracts you'll charge are the backup assembly, screwdriver with a T30 Torx arch bit, and a medium-sized flathead screwdriver. Before you activate the assignment of replacing a appendage ablaze assembly, about-face off your engine and accessible the trunk. You'll charge an able plan space, so aperture the block will acquiesce for this.
Begin by removing the old rear lamp assembly, if necessary. There are two T30 Torx bolts that authority the lamp place, an high and a lower bolt. Unscrew these bolts and cull the accumulation out of its place. The next footfall is to abstract the appendage ablaze wire from the car wire, application the flathead screwdriver. There is a baby blow central the affiliation collective section that you accept to cull up in adjustment to again abstract the wire.
Once you accept removed the old light, it's time to install the new light. Holding the new light, artlessly bung the accumulation wire into the car wire, authoritative abiding that the blow catches. Then, accurately adjust the appendage ablaze into the appendage ablaze abridged of the car. Finally, spiral the new rear lamp in place. Remove the artificial blur off the accumulation cover. Finally, analysis that the lamp works.